Accessories > Touch Probe Options
|
Accessories > Touch Probe Options |
Touch Probe Options |
|
Touch Trigger Probe |
Single point touch trigger probing extends measurement versatility of SmartScope® measurement systems. Using a touch trigger probe, you can measure features that are difficult to image, or surface boundaries that are inaccessible to video. Touch probe measurements can be part of any Measure-X® or MeasureMind® 3D MultiSensor measurement routine. A unique probe-to-optics offset calibration ensures that all sensors are referenced to the same coordinate system so measurements can use points from any sensor. Measurement accuracy is assured with a reference sphere and calibration software included with each touch probe accessory package. Touch probes, detachable stylus modules, change racks, and styli may be purchased from OGP®, or you can supply your own. Touch trigger probes are available for SmartScope Quest™, SmartScope Flash™,SmartScope ZIP, and SmartScope ATS systems. Probe Change Under Program Control Standard single point touch probe systems include a probe sensor, a detachable stylus module (DSM), and a 20 mm stylus with a 2 mm ruby ball. To increase versatility of your measurement system, add a 2-, 4-, or 6-position change rack, and fill it with the probes you use most. Probe access and return is programmable and fully automatic. Simply include probing in your measurement routine and the machine does the rest. |
 |
|
Add a contact contouring capability to SmartScope® Quest™ floor model systems with the SP25M scanning probe. Easy to use, simply select a start and end point and the scanning probe follows the part profile between those points. Using intelligent algorithms, MeasureMind® 3D MultiSensor metrology software drives the probe, rapidly following the part contour and collecting data points at a user defined velocity and data sampling rate. The scanning probe automatically adjusts point density when the probe is rounding curves. Both programming and measurement times are greatly reduced compared to single point probing. You can characterize your parts efficiently by using video measurement or edges, and the scanning probe for surface boundaries. For the ultimate in probing flexibility use the scanning probe with a PH-10 articulating head (available exclusively on the SmartScope Quest 650 with 400 mm Z travel). |
Scanning Probe |
 |
|
 |
|
Print this Page
Video & Multisensor • Optical Comparators • Laser Profile Scanners • Software • Accessories
